5 ANTI-FOG LENS OF PINLOCK
®
BRAND
The Pinlock
®
anti-fog lens, made of plastic material able to absorb moisture, limits
the tarnishing onset creating an insulating and airtight chamber that does not compro-
mise the field of vision.
Warning! The anti-fog devices delay the formation of the condensation, but do
not guarantee that the phenomenon does not arise: in presence of such a device
the time of tarnishing appearance will be larger. So, in extreme environmental
conditions the visor tarnishing can take place.
Warning! The usage of Pinlock
®
lens is always recommended with an air temper-
ature lower than 20° C and/or with higher moisture than 70% and/or in case of
rain.
5.1 INSTALLATION
Condition: the visor has been removed from the helmet and it has been
well-cleaned. The lens is placed on the visor inner surface, oriented
with the silicone gasket in contact with the visor.
• Slightly enlarge the visor (1) holding its extremities (arrows).
• Secure the lens (2) on the pins (3) of the visor; at first on one side,
then on the other.
• Make sure that the lens silicone gasket (4) perfectly adheres to
the visor for its entire length.
→ Remove the protective film from the
lens and install the visor on the hel-
met (see paragraph 4.3).
5.3 CLEANING
To clean the Pinlock
®
branded lens, use a mild liquid soap and a soft cloth moistened
with lukewarm water. Before installing it again, it’s necessary to let it perfectly dry for
a day at least. Do not dry by rubbing.
Warning! Do not use abrasive tools or aggressive products containing ammonia
or alcohol for cleaning.
2
3
1
4
5.2 REMOVAL
Condition: the visor has been removed from the helmet (see paragraph 4.2).
• Slightly enlarge the visor (1) holding its extremities (arrows).
• Lift the lens (2) by acting on its lower central part, so release it from the pins (3) you
find on the visor; first from one side, then from the other.
→ The lens is now detached. Remove it.
Warning! The Pinlock
®
branded lens must be handled with care and without the
aid of tools that can scratch it or abrade the surface.
11
EN
To Next Page
Loading...
