ahlmann AL 70e - Page 18

K65E/K75D/K95D/K95i 1-9 K65E/K75D/K95D/K95i 1-9
1.5.1.27 Avoid such work which
could have detrimental effect on
the stability of the machine.
The stability can be detrimented
by:
- overloading,
- too soft ground,
- abrupt acceleration or decelera-
tion of driving movement or
working movement,
- reversing out of high driving
speed,
- working on slopes,
- driving too quickly round sharp
bends,
- driving the machine on rough
terrain.
1.5.1.28 Do not drive along slopes
in traverse direction. Always carry
working equipment and loads near
the ground, especially when driving
down slopes. Sudden cornering is
forbidden!
1.5.1.29 On steep inclines and
gradients, the load is to be carried
on the uphill side.
1.5.1.30 Always adapt the speed
of the machine to the environmental
conditions when driving down
slopes! Never change into low gear
when driving on slopes but before
entering the slope!
1.5.1.31 Reversing over a longer
period must be avoided!
1.5.1.32 When leaving the
machine always safeguard the
machine to prevent it from
unintentionally rolling away or
prevent non-authorized persons
from using it!
1.5.1.33 The driver must not leave
the machine if the attachments are
not lowered or safeguarded.
1.5.1.27 Avoid such work which
could have detrimental effect on
the stability of the machine.
The stability can be detrimented
by:
- overloading,
- too soft ground,
- abrupt acceleration or decelera-
tion of driving movement or
working movement,
- reversing out of high driving
speed,
- working on slopes,
- driving too quickly round sharp
bends,
- driving the machine on rough
terrain.
1.5.1.28 Do not drive along slopes
in traverse direction. Always carry
working equipment and loads near
the ground, especially when driving
down slopes. Sudden cornering is
forbidden!
1.5.1.29 On steep inclines and
gradients, the load is to be carried
on the uphill side.
1.5.1.30 Always adapt the speed
of the machine to the environmental
conditions when driving down
slopes! Never change into low gear
when driving on slopes but before
entering the slope!
1.5.1.31 Reversing over a longer
period must be avoided!
1.5.1.32 When leaving the
machine always safeguard the
machine to prevent it from
unintentionally rolling away or
prevent non-authorized persons
from using it!
1.5.1.33 The driver must not leave
the machine if the attachments are
not lowered or safeguarded.