ahlmann AL 70e - Page 19

1-10 K65E/K75D/K95D/K95i 1-10 K65E/K75D/K95D/K95i
1.5.1.34 During work-brakes and
after work hours the driver should
endeavor to leave the machine on
good bearing soil and if possible on
level ground and safeguard the
machine to prevent it from
unintentionally rolling away.
1.5.2 Special work within
the exploitation of the
machine and elimination of
defects during process or
work; disposal
1.5.2.1
The prescribed dates for
adjustment work, maintenance work
and inspections laid down in the
operating manual (machine and
engine) must be strictly observed.
This also applies to details regarding
the interchanging of parts/ part
equipment. This work may only be
executed by skilled personnel.
1.5.2.2 For all work concerning the
operation, conversion or adjustment
of the machine and its safety devices
as well as inspection, maintenance
and repair work please observe the
switching and stopping operation in
accordance with the operating
manual (machine and engine) as
well as the related instructions for
maintenance work.
1.5.2.3 The engine must be
switched off before maintenance or
repair work is carried out.
1.5.2.4 The stability of the
machine or the attachments must be
guaranteed at all times during
maintenance and repair work.
1.5.2.5 Maintenance and repair
work may only be carried out when
the attachment is set down on the
ground or supported or when
equivalent measures against un-
intentional movement were taken.
1.5.1.34 During work-brakes and
after work hours the driver should
endeavor to leave the machine on
good bearing soil and if possible on
level ground and safeguard the
machine to prevent it from
unintentionally rolling away.
1.5.2 Special work within
the exploitation of the
machine and elimination of
defects during process or
work; disposal
1.5.2.1
The prescribed dates for
adjustment work, maintenance work
and inspections laid down in the
operating manual (machine and
engine) must be strictly observed.
This also applies to details regarding
the interchanging of parts/ part
equipment. This work may only be
executed by skilled personnel.
1.5.2.2 For all work concerning the
operation, conversion or adjustment
of the machine and its safety devices
as well as inspection, maintenance
and repair work please observe the
switching and stopping operation in
accordance with the operating
manual (machine and engine) as
well as the related instructions for
maintenance work.
1.5.2.3 The engine must be
switched off before maintenance or
repair work is carried out.
1.5.2.4 The stability of the
machine or the attachments must be
guaranteed at all times during
maintenance and repair work.
1.5.2.5 Maintenance and repair
work may only be carried out when
the attachment is set down on the
ground or supported or when
equivalent measures against un-
intentional movement were taken.