The DRO will enter self-checking process when the power is
switched on.This self-checking process is to check the displaying
of LED, resolution and machine mode.Once the process
completed,the DRO will enter working status.
While DRO is under self-checking process,press to enter
the parameter setting.The setting includes the following:
1. Encoder type Setting(Linear or Rotary)
2. Resolution
3. Counting Direction(0 indicates positive,1 indicates negative)
4. Compensation Type(Linear or Non-Linear)
5. Imperial Decimal Setting
6. Number of axis setting
7. Machine mode
2. System Parameter Setting
ENT
System Parameter Setting
To Next Page
Loading...