3.2.3 Update of AMC / APM / AP104 / USB boards
Install the new drivers as explained in Section 2.2.2
Select Start | Run..., then in the Run window, click the Browse... button and navigate to:
c:\Program Files\AIM GmbH\PCI-1553-Windows-BSP-Vxxxx\Onboard-SW
From the Onboard-SW directory, navigate into the subdirectory which corresponds to the
type AIM 1553 module you are updating. In the module specific subdirectory, select the
Update_Axx1553.bat file, then the Open button.
For a specific description of the update procedures please have a look into the
Read_me_first.pdf file, which is located in the same directory.
Reboot the system (cold reboot with a power off time of about 10 seconds!!!).
To Next Page
