Aim MIL-STD-1553 - Default Chapter; Table of Contents

v
TABLE OF CONTENTS
Section Title Page
1 INTRODUCTION....................................................................................................... 1
1.1 About This Manual ................................................................................................... 1
1.2 How This Manual is Organized ................................................................................ 2
1.3 General Documentation Conventions ...................................................................... 3
1.4 Applicable Documents ............................................................................................. 4
2 NEW BSP AND HARDWARE INSTALLATION PROCEDURE ........................ 5
2.1 BSP Installation ........................................................................................................ 5
2.2 Hardware Installation (API1553) ............................................................................. 8
2.2.1 Installing the AIM Hardware ............................................................................... 9
2.2.2 Installing the Windows system driver................................................................ 10
3 BSP UPGRADE PROCEDURE .............................................................................. 17
3.1 Install the New BSP ............................................................................................... 17
3.2 Update the Onboard Flash Firmware ..................................................................... 18
3.2.1 Update of API / ACI / APX1553 boards ........................................................... 18
3.2.2 Update of AEC/AXC/AMCX/APE boards ........................................................ 18
3.2.3 Update of AMC / APM / AP104 / USB boards ................................................. 19
3.3 Removing Previously Installed Drivers and BSP ................................................... 20
3.3.1 Removing the Windows system driver and BSP ............................................... 20
4 CONNECTING THE AIM MODULE TO THE BUS .......................................... 23
5 COMPILING AND RUNNING A SAMPLE PROJECT...................................... 27
6 NOTES ....................................................................................................................... 31
6.1 Acronyms and Abbreviations ................................................................................. 31
7 DOWNLOADING THE BSP FROM AIM-ONLINE ........................................... 34