Aim MyChron5 660 - Page 2

1
INDEX
1 – MyChron5 660 in a few words 2
2 – What is in the kit 3
3 – Installation, connections and powering 4
3.1 – Installing MyChron5 660 4
3.2 – Installing the RPM wire 4
3.3 – Installing Exhaust Gas thermocouple 5
3.4 – Installing the Cylinder Heat Thermocouple 6
3.5 – Installing the speed sensor 7
3.6 – Connecting MyChron5 660 to sensors and LCU-One CAN expansion 8
3.7 – Powering MyChron5 660 10
4 – MyChron5 660 keyboard and configuration 11
4.1 – Configuration Wizard 12
4.2 – Configuration Menu 13
4.2 – Backlight 14
4.3 – System Settings 15
4.3.1 – Drive Setup 16
4.3.2 – RPM Setup 16
4.3.3 – Unit of measure 17
4.3.4 – LED Setup 17
4.3.5 – System Info 18
4.4 – Engine Pass Counters 18
4.5 – Date time 19
4.6 – Wi-Fi 19
4.7 – Language 20
4.8 – Configuration Wizard (see paragraph 4.1) 20
4.9 – Clear memory 20
5 – Data Recall 21
6 – Connection to the PC 22
7 – Data download and Analysis 24
8 – W-Fi Configuration 25
8.1 – Configuring MyChron5 660 as an Access Point (AP) 28
8.2 – Adding MyChron5 660 to an existing network 31
8.3 – Wi-Fi network settings 33
8.4 – The Internet connectivity 34
8.5 – Connection issues 34
8.6 – Working on Mac
TM
with virtualized Windows
TM
35
8.7 – Connected device visualization issues 37
9 – Firmware and software upgrading 38
10 – Technical specifications and drawings 39