CHAPTER 7
26 27
SOLO 2 DL
To set other parameters create a unique password to protect your device/your
network.
With a password the communication is safe and encrypted using WPA2-PSK
standard.
Characters allowed in the password are all letters, also capital, all digits and these
characters: ‘+-_()[]{}$£!?^#@*\\\”=~.:;/%"
“Space” type can be used if it is not the first one because this could cause
incomprehension in some Windows
TM
versions.
This AP or SSID name is unique for your device.
An example of name is:” AiM-Solo2DL-00103” where:
n
“AiM” is the prefix of all AiM devices
n
“Solo 2DL” is the device identifier
n
“00103” is your device serial number assigned by the factory.
To make your device more recognizable you can add a name to the SSID. The limit is
of eight characters. Allowed characters are all letters, capital too, all digits and these
characters: ‘+ - _ () [] {}!.
“Space” type can be used provided that it is not the first one because it can cause in-
comprehension in some Windows
TM
versions.
If, for example you add the driver’s name, Tom Wolf, the network name (SSID) becomes:
”AiM-Solo2DL-00103-TomWolf”
Once all parameters set click “Transmit”. Solo 2 DL reboots and is configured with the
new parameters. If Solo 2 DL is protected by a password, as recommended, Race
Studio 3 will ask that password to authenticate.
Please Note: the same Wi-Fi connection can be created with the operative system tool.
Once the device has been authenticated in the Wi-Fi network you can communicate
with it using Race Studio 3.
To Next Page
Loading...