EasyManua.ls Logo

AIMA A05 - Page 12

AIMA A05
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
产品使用手册10
Product Instruction Manual
电机控制器的保养
Maintenance of Controllor
每三个月应到爱玛服务站检查电机控制器的欠压、过流保护、刹车断电等功能及接插件是
否松动。
Every three months, go to AIMA Service Station to check the functions of under voltage,
overcurrent protection, brake disconnection of the controller and whether the connector is loose.
曰常使用无需维护控制器,但听到电机控制器部位有异响时,请到爱玛服务站进行维护,
不允许私自拆装电机控制器。避免使电动车涉水超过电机控制器部位,若发生此种情况请
停止使用电动车,避免因插件部位进水短路引起故障。
There is no need to maintain the controller when in daily use However, when hearing the
abnormal noise of the motor controller, please go to AIMA service station for maintenance, and it
is not allowed to disassemble and assemble the motor controller without permission. Avoid
allowing electric vehicles to wade beyond the motor controller. If this happens, please stop using
the electric vehicle to avoid failure caused by short circuit of water entering the plug-in part.
请使用爱玛专用电机控制器,严禁私自更换,或更改电路。
Please use the special motor controller of AIMA, and it is forbidden to replace or change the
circuit without permission.
停车注意事项
Parking precautions
1.当您下车应拉紧手刹,防止溜坡。
1.When get off the car, tighten the hand brake to prevent slipping.
2.应避免静止时频繁启动车辆,以保证电池、电机及电器开关的使用寿命停车时应关闭电源。
2.Avoid frequently starting the vehicle when stationary to ensure the service life of battery, motor
and electrical switch, turn off the power supply.
整车关键位置扭矩清单:
Torque list at key positions of vehicle:
标准件使用位置
Using position of standard parts
扭矩(Nm)
Torque
(Nm)
标准件使用位置
Using position of standard parts
扭矩(Nm)
Torque
(Nm)
左、右前下摆臂总成-车身
Left and Right Front Lower Arm
Assembly-carbody
70±8
车门饺链
Dumpling chain for vehicle door
23±2
左、右前下摆臂总成球头转向节
Left and right front lower swing arm
assembly ball steering knuckles
50±5
方向机拉杆球头转向节
Steering Wheel Rod Ball
Head-Steering Knuckle
50±5
左、右前减震器-车身
Front left and right shock
absorper-carbody
23±2
制动踏板-车身
Brake Pedal-carbody
23±2
左、右前减震器-转向节
Front left and right shock
absorper-steering knuckle
70±8
制动灯开关锁紧螺母
Brake light switch lock nut
15±3
拖曳臂后桥(U 型螺栓)
Towing Arm-Rear Axle (U-bolt)
45±5
制动总泵制动踏板
Braking master cylinder-brake pedal
23±2
拖曳臂-车身
Towing Arm-carbody
70±8
制动管三通接头-车身
Brake Pipe Tee- carbody
23±2
后悬架横拉杆总成-车身
Rear Suspension Tie Rod
Assembly-carbody
70±8
左、右前制动卡钳-转向节
Left and right front brake
calipers-steering knuckle
23±2
后悬架横拉杆总成后桥
Rear Suspension Tie Rod
Assembly-Rear Axle
70±8
左、右后制动卡钳-后桥
Left and right rear brake callipers-
Rear Axle
23±2
后减震器-车身
Rear spring strut- carbody
70±8
驻车制动拉索左、右后段总成护套
前、后端锁紧螺母
Front and rear lock nuts of left and
right rear segment assembly sheath
of parking brake cable
23±2
后减震器-后桥
Rear Shock Absorber-Rear Axle
70±8
转向管柱车身
Steering Stem- carbody
23±2
驻车制动手柄-车身
Parking Brake Handlebar- carbody
23±2
紧固转向中间轴
Fasten steering middle shaft
23±2
双螺母锁紧手刹线(手刹手柄处)
Double nut locking hand brake line
(at hand brake handlebar)
1
方向机-车身
Directional Machine- carbody
23±2
加速踏板-车身
Accelerator Pedal- carbody
1