产品使用手册11
Product Instruction Manual
车辆参数
Inspection and maintenance
外形尺寸(长 X 宽 X 高）
Overall Dimension (length× width × height)
一次充电续行里程
One-time charging mileage
充电器输入电压
Charger Input Voltage
欠压保护值
Undervoltage protection value
过流保护值
Overcurrent protection value
永磁同步
feirranent magnet synchronous
轮胎规格前/后
Tire specification front/rear
注：以上参数为我司常规车型的技术参数，具体技术参数以实物车为准。
Note: The above parameters are the technical parameters of our regular vehicle model, and the specific
technical parameters shall be subject to the actual vehicle.
本公司保留对整车外观、配件优化及尺寸规格变更的权利。
Our company reserves the right of the optimizing the appearance, accessories and the change in size and
specification of the whole vehicle.
如有相关参数调整，恕不另行通知，敬请谅解
Please understand if relevant parameters are adjusted, no further notice will be informed .
故障现象与排除 Failure and Troubleshooting
排除方法 Elimination solution
打开电源仪表无显
示调速失灵
speed regulation
fails, but when
switch on the
power supply
instrument, there is
no display.
1 保险丝断路
1.Fuse open circuit
2 电源插头与电池插座接触不良
2.Poor contact between power plug and
battery socket
3 电源锁开关损坏或插件接触不良
3.The power lock switch is damaged or
the plug-in is poorly connected
1 查明原因并更换保险丝
1.Find out the cause and replace the
fuse
2 更换电源插头或电池插座
2.Replace the power plug or battery
socket
3 更换电源锁或接插件
3.Replace the power lock or connector
接通电源仪表显示
正常调速失灵
Speed regulation
fails, but when
switch on the
instrument, it
displays normal
1 电池电压过低
1.Battery voltage is too low
2 调速把损坏或松动
2.The speed regulating handle is
damaged or loose
3 左或右断电刹把失灵
3.Left or right power-off brake handle is
failed
4 控制器或电机故障
4.Controller or motor failure
1 充足电
1.Fully charged
2 更换调速把或夹紧
2.Replace the governor handle or clamp
it
3 更换断电刹把
3.Replace the power-off brake handle
4 修理或更换控制器、电机
4.Repair or replace the controller and
motor
—次充电后续里程
不足
Insufficient mileage
after charging
1 蓄电池充电不足
1.Insufficient charging of battery
2 轮胎气压不足
2.Insufficient tire pressure
3 上坡多、逆风大、频繁刹车载重大
3.More uphill, strong wind, frequent
braking and heavy load
4 蓄电池老化或损坏
4.Battery aged or damaged
5 检查刹车是否调整到位
5.Check whether the brake is adjusted in
place
6 检查转动、传动部件是否处于润滑状
态
6.Check whether the rotating and driving
parts are in lubrication state
1 充足电或检查充电器插头是否接触
不良
1.Fully charged or check the charger
plug for poor connection
2 充足气
2.Sufficient tire pressure
3 尽量减少刹车、启动次数和载重情
况
3.Minimize braking, start-up times and
loading
4 维修或更换蓄电池
4.Repair or replace the battery
5 调整刹车状态
5.Adjust brake status
6 给转动、传动部件润滑
6.Lubricate rotating and driving parts
蓄电池充不进电
Battery cannot be
charged
1 充电器插头与蓄电池插座连接松动
1.The connection between charger plug
and battery socket is loose
2 电池组接线脱落
2.The wiring of the battery pack falls off
3 充电器内保险丝烧断
3.The fuse inside the charger is blown out
1 更换插头或插座
1.Replace plug or socket
2 焊接连接线
2.Welding the connecting wire
3 更换充电器
3.Replace the charger
注：当您遇到在上述指导下无法自行排除的故障时，请与当地经销商或维修站联系。在质保期内切勿
擅自打开重要部件，否则会失去本公司的质保承诺。
Note: When encounter failures that cannot be corrected by userselves under the above guidance, please
contact local distributor or service station. Do not open important parts without authorization during the
warranty period, otherwise our warranty promise will be exempted.
To Next Page
Loading...