Setting Up Your Aipas eBike Setting Up Your Aipas eBike
18 19
Fire and explosion hazards. Never leave your battery battery unattended while
charging to prevent serious injury or death.
The battery can be charged either by removing it from the bike or while it is installed on the
bike.
1.Put the key into the lock, turn it to the left which is the direction for unlocking.1.
When the battery is unlocked, it will pop down.2.
Prop up the battery with your left hand and then remove the battery with both hands.3.
When charging the battery without removing it, first remove the dust plug located on the
frame, then insert the charging connector into the charging port.
2.
When charging the battery after removing it, directly insert the charging connector into the
battery's charging port.
3.
Typically, the charger’s indicator light shows red while charging, green when fully charged,
and also red when not charging.
4.
You should fully charge the battery before your first ride.
Charge The Battery
WARNING!
Removing the Battery:
First, place the bottom of the battery into the frame.1.
Then gently press the top of the battery.2.
When you feel resistance, press the battery slightly harder until you hear a click.3.
Installing Battery:
Note: When unlocking and removing your battery pack from the frame, take care that it does not
slide out.If your battery impacts the ground and is damaged, discontinue use and contact Aipas
eBikes immediately.
Note: Make sure the battery is installed properly and tightly with the frame, it will match the
frame smoothly.
To Next Page
