- 7 -
1 In the standby mode, pressing the [ GUARD] button will make the
STATUS LED flash and a call confirmation tone will sound.
2 A tone will sound at the security guard station.
• The in use LED (orange) at all of the connected entrance stations will light up.
• If there is no answer, a call record will be stored in the security guard sta-
tion, and notification of the call will be sent to the security guard.
Calling security guard stations3-1
3
CALLING
1 In the standby mode, press the [ ] button to display the camera vid-
eo images in order from entrance 1. Audio can heard at the same time.
The STATUS LED will light up.
• Listening is possible with hearing aids with T-mode. (GT-1C-L only)
1. It will take some time after pressing the [ ] button for the picture
to display, so please wait for the monitor picture to display before
performing the next button operation.
2. This function may not be operated due to the equipment being used.
4
MONITORING
NOTES: 1. If there is an operation such as a call, monitoring ends and the call
operation begins.
2. Monitoring will automatically end if monitoring is performed at
another residential station.
3. Press the [ TALK] button during monitoring to communicate
with the entrance station being monitored.
4. During monitoring, the display uses a wide picture display. (If the
[
ZOOM/WIDE] button is pressed, the display changes to the
zoom picture.)
5. Monitoring will automatically end after 30 seconds.
To Next Page
Loading...
Need help?
General
