29
How to use
Placing / Answering a Call
3
Note
• The call is placed using the priority that was set during
programming.
• The call ring timer and the ringback tone count may vary
depending on the settings.
• When calling a VoIP Phone, this will be the shorter time of
the time set for "Call Timeout" and the call duration set on
the IP-PBX.
• A call tone may not sound, depending on the settings.
• Depending on the settings, communication sounds may
play from separately installed speakers.
• A call start notification tone or message may play when the
call starts, depending on the settings.
• If the call duration set on this station elapses, the call will
automatically end. A notification tone will play
approximately 10 seconds prior to the call ending. The
notification tone may not play, depending on the settings.
• If a page with a higher priority is received from another
station while making an outgoing call or during
communication, the outgoing call or call will be interrupted
and the station will switch to the page.
• If Change Destination by Time Delay or a schedule is set,
outgoing calls will be placed according to the
setting.
(→page 56)
• If call recipients include a VoIP Phone configured to
automatically take the call, that VoIP Phone will answer.
To Next Page
Loading...
