51
Settings and Adjustments
Station programming
4
Network Settings
Video (for IX-EA, IX-DV and IX-DVF(-*))
■ Video Encoder 1
Configure the video encoder for transmission between IX stations. The coding system used is H.264 / AVC.
*1 Indicates a required field. Use the default values, unless a change is necessary.
Important
• When the "Frame Rate" is set to 7.5, 10, 15, 20 or, 30 fps, after approximately 10 minutes following the start of an outgoing
call, the frame rate will automatically drop to 5 fps.
Note
• The frame rate or bit rate may be lower than the set value depending on the video being sent, the number of recipient stations,
and the network environment.
Entry Description Settings Default values
Resolution Select the video resolution of Video Encoder
1.
• 320×240 (QVGA)
• 640×480 (VGA)
640×480 (VGA)
Frame Rate [fps] Set the Frame Rate [fps] of Video Encoder
1.
1, 2, 3, 5, 7.5, 10, 15, 20, 30 15
Select Profile Select the H.264/AVC Profile of Video
Encoder 1.
• Baseline
• Main
• High
Main
I-picture interval
*1
Set the interval to send H.264/AVC I-picture
of Video Encoder 1.
1 - 100 15
Bit rate [kbps] Set the H.264/AVC Bit Rate of Video
Encoder 1.
32, 64, 128, 256, 384, 512,
768, 1024, 2048
1024
To Next Page
Loading...
