66
Settings and Adjustments
Station programming
4
Entry Description Settings Default values
Authentication Key Set the Authentication Key when "Door
Release" is selected in "Function
(administrator setting)" for releasing the
door that is connected to the station. When
the "Authentication Key" is confirmed, the
relay output will be activated. This will also
be the authentication key used to release
the door using the numerical keypad on IX-
MV7-* or the VoIP Phone.
1 - 20 digits -
Sound Settings Configure tones for the output terminal.
• Door Release: Select the Door Release
sounds to be played.
• Relay Control (start): Select the sound to
be played when Option Relay is activated.
• Relay Control (end): Select the sound to
be played when Option Relay is
deactivated.
• None
• Call Pattern 1
• Call Pattern 2
• Call Pattern 3
• Call Pattern 4
• Call Pattern 5
• Call Pattern 6
• Call Pattern 7 (for IX-EA)
• Tremolo Sound
• Busy Response Tone
• On Hold
• Operation Sound
• Error
• Pre Tone 1
• Pre Tone 2
• Pre Tone 3
• Communication End
Pretone
• Call Queue Notification
• Waiting Reply Tone
• Select a sound that is
registered in
“Custom
Sound Registry
(→page 54)” can also be
selected.
Door Release:
Operation Sound
Relay Control (start):
None
Relay Control (end):
None
Important
• Configure the authentication key using 1 to 4 digits if the electrical lock connected to this device will be released by operating
IX-MV.
• Configure a different authentication key for each output terminal (the same key cannot be configured.)
• Configure a different authentication key than the authentication key configured in
“Communication Audio Messages
(→page 76)” and "Option Relay Control Authentication Key." If it is the same, both functions might operate.
Note
• The "Authentication Key" is displayed as "●●●●●" in the Settings screen.
To Next Page
Loading...
