- 2 -
General Precautions
• Install low-voltage lines at least 30cm (11") away from high-voltage lines (AC100V, 200V), especially inverter air conditioner
wiring. Failure to do so may result in interference or malfunction.
• When installing or using the device, give consideration to the privacy rights of subjects, as it is the responsibility of the system
owner to post signs or warnings in accordance with local ordinances.
Notice
• If the device is used in areas where there are business-use wireless devices such as a transceiver or mobile phones, it may
cause malfunction.
• If the device is installed close to a light dimmer, an inverter electrical appliance or the remote control unit of a hot-water system
or floor-heating system, it may create interference and cause a malfunction.
• If the device is installed in an area with an extremely strong electrical field, such as in the vicinity of a broadcasting station, it
may create interference and cause a malfunction.
• If warm air from inside the room enters the unit, the internal and external temperature difference may cause condensation on
the camera. Plugging of cable holes and other gaps where warm air might enter is recommended for preventing condensation.
Precautions for mounting
• If installed in the place where the sound is easy to echo, it may be difficult to hear the conversation with echoed sounds.
• Installing the device in locations or positions such as the following may affect the clarity of the image:
– Where lights will be shining directly into the camera at night time
– Where the sky fills much of the background
– Where the background of the subject is white
– Where sunlight or other strong light sources will shine directly into the camera
• In 50Hz regions, if a strong fluorescent light shines directly into the camera, it may cause the image to flicker. Either shield the
camera from the light or use an inverter fluorescent light.
• Installing the device in the following locations could cause malfunction:
– Locations that get hot
Close to a heater, boiler, etc.
– Locations where there is risk of exposure to liquid, dust, oil, or chemicals
– Locations with high humidity
Bathroom, basement, greenhouse, etc.
– Locations with low temperature
Inside a cold storage warehouse, the front of a cooler, etc.
– Locations directly exposed to steam or oil smoke
Next to heating devices or a cooking space, etc.
– Sulphurous environments such as a hot spring area
– Locations close to the sea or directly exposed to sea breeze
• If existing wiring is used, the device may not operate properly. In that case, it will be necessary to replace the wiring.
• Do not, under any circumstances, use an impact driver to fasten screws. Doing so may cause damage to the device.
Where the sky fills much of
the background
Where the background of
the subject is white
White
wall
Sky
Where sunlight or other strong light sources
will shine directly into the camera
To Next Page
Loading...
Need help?
General
