Air Weigh LoadMaxx Plus - Installing the Deflection Sensors

11
Installing the Deection Sensors
Repeat the below steps for both front and rear deection
sensor install.
Note:
1. Use two bolts, nuts and washers to install the deection sensor
inside each bracket.
2. Insert the deection sensor into the sensor bracket with the
engraved lettering facing up and its cable extending toward
the side of the trailer where you will route the sensor extension
cable from the trailer scale display.
NOTE: Use the SHORTER cable for the Front (Tandem) or
Middle (Tri-axle) axle. Use the LONGER cable for the Rear
axle. You can determine the cable length by the middle four digits of
the part number on the cable (ex: 2500 = 25 feet).
3. Insert both bolts through the hexagonal holes that hold the bolt
head.
4. Place a washer and a nut at the end of each bolt and hand
tighten the nut.
Trailer Axle Sensor Installation