EasyManua.ls Logo

Air Weigh LoadMaxx Plus - Tools Required for Installation

Air Weigh LoadMaxx Plus
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
Tools Required
You will need the following tools to install the trailer scale and
deection sensors:
• Standard wrench set or adjustable wrench
• Drill with ¼-inch drill bit, or larger if ush mounted
• Flush wire cutter
• Needle nose pliers
• Grinder
• Chalk or permanent marker
• MIG or ARC welder
• Torque wrench
• 22mm socket
• Enamel spray paint, any color
• Tape measure
• C-clamps (2)
Optional Tool
• Deection sensor test box, p/n 1001
Note: Use the bracket template that has been provided with your
trailer kit and follow directions on the template to double check that
the bracket will t.
Note: Bracket is installed on the front and rear axles for tandem
trailers and on the center and rear axles for tri-axle trailers.