15
Final Sensor Torque
1. Torque both nuts to 120 ft/lbs.
2. Apply supplied Loctite to the exposed threads of the bolts.
3. Perform a nal check to A/D values using the readings from
the trailer scale display, not from the A/D Box. If A/D readings
are not within range, repeat the Adjusting the A/D reading
steps.
Adding a Protective Spray Paint Coating
Using any enamel-based spray paint, paint the bracket, the welded
sections, and all bare metal around the bracket completely.
Note: After nal torquing, the sensor will require a break-in period
before it can be calibrated. We recommend driving the vehicle
in normal operation for at least 100 miles before performing the
calibration. If the vehicle operates on very smooth roads during
break-in, more miles may be needed to achieve an adequate amount
of suspension vibration.
To Next Page
Loading...