To Next PageTo Next PageHow to troubleshoot AIRBORNE Activ Fan that does not power up?
If your AIRBORNE Fan doesn't power up, there could be a couple of reasons. First, check that the dwelling’s fuse or circuit breakers haven't failed or tripped, and ensure that 240V is available at the Terminal Block. Also, make sure the isolation switch is turned on.
Why is my AIRBORNE Activ so noisy?
If your AIRBORNE Fan is making noise, check that all screws and parts are secured firmly, being careful not to overtighten them. Make sure there are no loose parts moving inside the motor housing. Also, ensure that the ceiling bracket is secure.
What to do if my AIRBORNE Activ Fan wobbles?
If your AIRBORNE Fan wobbles, ensure the fan is switched OFF before troubleshooting. Here's what to check: * Make sure each blade has the same weight (with a 3gm buffer). * Tighten all screws, being careful not to overtighten them. * Ensure the ceiling bracket is tight against the ceiling and that the ceiling structure isn't moving. * If countersunk screws were used, replace them with the screws supplied in the box.
Why doesn't my AIRBORNE Activ Fan move much air?
If your AIRBORNE Fan isn't moving much air, it might be in winter mode. Use the remote control to switch the fan from winter (reverse) to summer mode.
What to do if AIRBORNE Activ light is flickering?
If the light on your AIRBORNE Fan is flickering or pulsing, disconnect and reconnect the receiver and light kit to ensure the connections are seated correctly. Also, check earth continuity to ensure both the fan and light kit are earthed.
How to fix AIRBORNE Activ light that doesn't turn on?
If the light on your AIRBORNE Fan doesn't turn on, first ensure the fan is switched OFF before troubleshooting. Check the circuit breakers, fuses, and isolation switch to make sure there is power to the fan. Also, inspect the wires in the light kit assembly for any looseness. If the issue is with the remote control, refer to the remote control troubleshooting steps.
Essential safety instructions, user care, and prohibitions for safe operation and preventing injury.
Key requirements for installation, electrical setup, and warranty claims, including necessary certifications and exclusions.
Details on what damages are not covered by warranty and the policy regarding service call fees.
Ensures adequate floor clearance, object clearance, and secure mounting to a load-bearing structure for safety.
Guides on safe handling of fan parts and proper tightening of screws during assembly to prevent injury or damage.
Details how the fan circulates air downwards for a cooling effect during summer.
Explains how the fan circulates air upwards to distribute warm air during winter.
Instructions on how to clean the fan's motor housing and blades safely and effectively to prevent damage.
Explains factors contributing to wear and tear, especially in coastal or humid environments, and warranty exclusions.
Solutions for issues where the fan does not power up or experiences wobbling.
Addresses causes and solutions for fan noise and problems with the fan's light not turning on.
Provides guidance for poor airflow and intermittent light flickering or pulsing issues.
Details what is not covered by warranty and the procedure for making a warranty claim.
Outlines warranty duration for the fan, control system, and conditions for warranty transfer.
Verifies correct controller usage, grounding of fan components, and secure bracket mounting.
Confirms adequate blade clearance from the floor and checks fan speed operation and light functionality.
General