National Warranty Hotline|1300 116 305 Monday to Friday 9am to 5pm AEST
14
1.
Ceiling fan is not installed using a solid-state wall controller. Wall controllers must only be types
approved for use by AeroDC.
2. The fan, fan light assembly and bracket are earthed.
4.
Mounting bracket must be rmly secured to a solid structure such as a concrete ceiling, steel structure
or timber framing. If additional bracing is added it must be rmly secured to the rafters and not left
oating on the ceiling.
5. Counter sunk screws are not to be used to attach bracket to ceiling.
6. Fan blades are at least 2.1m (7 feet) above oor level.
7. Check the fan is operating correctly on all speeds.
8. If light is installed. Check light is functioning properly.
ELECTRICIAN CHECKLIST
Electricians make sure everything on this checklist is ticked off before you leave the installation site. If you have trouble
installing our product please refer to the trouble shooting section on page 11 rst, then phone the AeroDC Warranty
Hotline on 1300 116 305 (open 9am to 5pm EST). DO NOT uninstall the fan unless asked to do so.
To Next Page
Loading...