AiRide Firestone - Factory Reset

2
930 Installation Instructions 12
ECU POWER UP/APP PERFORMANCE
6
FACTORY RESET
(TROUBLESHOOTING ONLY)
• Remove fuse from red wire by battery or
remove wire harness connector from ECU
• Remove app from phone
• Reinstall fuse or plug wire harness
connector back into the ECU
• Download the app
The ECU will remain active for two hours
after initial installation or factory reset.
After voltage drop due to engine
stop, the ECU will remain active for up
to thirty minutes.
9961 ECU
A SOLID GREEN LED
ON THE ECU INDICATES
BLUETOOTH IS CONNECTED
OVER THE AIR FIRMWARE UPDATE
If an OTA update is available, a popup will appear on the app to activate.
After voltage drop due to engine stop, the ECU will remain active for five minutes.
• If you select SKIP, the firmware can be updated once connected to the app
• If you select INSTALL, the firmware will begin to update. This will take approximately 3-4 minutes
• Keep the app open during the update and stay within range of the ECU until complete
• Once OTA is complete, restart the app, use the default passkey, and use as normal