1 firestoneairide.com
IMPORTANT
PLEASE DON’T HURT YOURSELF, THE KIT, OR YOUR VEHICLE. TAKE A MINUTE TO READ THIS IMPORTANT INFORMATION.
SAFE INSTALLATION
Please take all safety precautions during installation. A hydraulic jack can fail, and if that happens, you can be
seriously hurt, or worse, if you are relying on it to hold up the vehicle. If you use a hydraulic jack, secure jack
stands in the appropriate locations and chock any tires still touching the ground.
Wear safety glasses or goggles. Your eyes may be lower than some parts and pieces, and you don’t want to lose an eye.
Remove the possibility of any electrical issues by disconnecting the negative battery cable.
VEHICLE GVWR
NEVER exceed the maximum load recommended by the vehicle manufacturer (GVWR). The GVWR can be found
in your vehicle’s owner’s manual or on the data plate on the driver’s side door. Consult your local dealership for
additional GVWR specifications.
PRESSURE TO LOAD
Be sure to review the load limits noted in the Air Spring Kit Installation Instructions (sold separately).
APPROPRIATE AIR PRESSURE
For best ride, use only enough air pressure in the Air Springs to level the vehicle when viewed from the
side (front to rear). This will vary, depending on the load, location of the load, condition of the existing
suspension, and personal preference.
ONCE INSTALLED SUCCESSFULLY, FOLLOW THE PRESSURE REQUIREMENTS FOR THE AIR SPRINGS.
FOR FIRESTONE, GENERALLY:
305
1005
COIL-RITE
RIDE-RITE
To Next Page
Loading...