Why is my AIRLESSCO Paint Sprayer causing excessive fogging?
If your AIRLESSCO Paint Sprayer is producing excessive fogging or overspray, it's likely due to high pressure or the material being too thin. Try reducing the pressure until you achieve a satisfactory spray pattern. If the material is too thin, use less thinner.
Why is the spray pattern from my AIRLESSCO Paint Sprayer irregular?
If the spray pattern from your AIRLESSCO Paint Sprayer is irregular or deflected, it's probably because the orifice is clogged or the tip is damaged. Carefully clean the tip. If that doesn't work, replace it with a new one.
What to do if my AIRLESSCO Paint Sprayer sprays too much material?
If your AIRLESSCO Paint Sprayer is spraying too much material, it could be due to a nozzle that's too large, material that's too thin, or pressure that's too high. Try using a smaller nozzle and reducing the pressure.
How to prevent thick skin when using AIRLESSCO SL1500 Paint Sprayer?
If you're getting a thick skin on your work when using the AIRLESSCO Paint Sprayer, the material is likely too viscous or the application is too heavy. Thin the material cautiously. You can also reduce the pressure and/or use a tip in the next smaller nozzle group.
How to fix coarse spray with AIRLESSCO SL1500?
If your AIRLESSCO Paint Sprayer is producing a coarse spray, it is likely that the pressure is too low. Increase the pressure to resolve this issue.
What to do if coating fails to close & smooth over with AIRLESSCO Paint Sprayer?
If the coating fails to close and smooth over when using your AIRLESSCO Paint Sprayer, it's likely because the material is too viscous. Thin the material cautiously to resolve this.
Why AIRLESSCO SL1500 Paint Sprayer sprays too little material?
If your AIRLESSCO Paint Sprayer is not spraying enough material, it could be because the nozzle is too small or the material is too thick. Try using the next larger nozzle.
How to fix thin distribution in center of pattern from AIRLESSCO SL1500 Paint Sprayer?
If the distribution in the center of the pattern from your AIRLESSCO Paint Sprayer is thin, creating “horns”, it's likely due to a worn or wrong tip. Change to a new tip or use a nozzle with a narrow spray angle.
Why is the pattern too wide with my AIRLESSCO SL1500?
If the pattern from your AIRLESSCO Paint Sprayer is too wide, it means the spray angle is too large. Use a smaller spray angle tip.
Why is the pattern too narrow with my AIRLESSCO Paint Sprayer?
If the pattern from your AIRLESSCO Paint Sprayer is too narrow, it means the spray angle is too small. Use a larger spray angle tip. If coverage is OK, try a tip in the same nozzle group.
General| Type | Airless Paint Sprayer |
|---|---|
| Max Pressure | 3000 PSI |
| Power Source | Electric |
| Hose Length | 50 ft |
| Spray Tip Size | 0.015 inch |
To Next Page