AirMan PDS185S-6B4 - User Manual

Questions and Answers

Q
qdaltonAug 15, 2025
What to do if my AirMan PDS185S-6B4 Air Compressor starter rotates but the engine doesn't start?
- J
  Jessica BaileyAug 15, 2025
  If the starter rotates but the engine doesn't start, there could be several reasons: * The fuel filter might be clogged. In this case, disassemble, clean, and change it. * There may be a malfunction of the fuel cut solenoid or motor stopper. Check the fuse and change the solenoid or motor stopper. * The compressor may be out of fuel. Replenish the fuel.
M
mandersenAug 18, 2025
Why is my AirMan PDS185S-6B4 Air Compressor not reaching its maximum speed?
- T
  Travis BurnsAug 18, 2025
  There are several reasons why the engine might not reach its maximum speed: * The speed regulator rod may be improperly adjusted. Try re-adjusting it. * The unloader orifice might be clogged. Disassemble and clean it. * There could be a faulty speed regulator. Disassemble and check it. * The fuel filter may be clogged. Disassemble and change it. * There may be engine trouble. In this case, call your nearest dealer.
B
Brandon HayesAug 21, 2025
What causes oil to mix in the air of my AirMan PDS185S-6B4?
- X
  xshafferAug 21, 2025
  Oil mixing in the air, indicating poor oil separation, can be caused by several factors: * The scavenging orifice strainer might be clogged. Disassemble and clean it. * There may be excessive oil in the tank. Drain it to the proper level. * There might be low discharge pressure. Disassemble the unloader and check it. * The oil separator may be deteriorated. Disassemble and change it.
D
Dawn RossAug 25, 2025
What to do if the safety valve on my AirMan PDS185S-6B4 relieves at unload?
- J
  Jennifer DuranAug 26, 2025
  If the safety valve relieves at unload, consider these potential causes: * The pressure regulator might be insufficiently adjusted. Re-adjust it by loosening. * The speed regulator diaphragm may be damaged. Change it. * The unloader valve might be damaged, or the seat may be malfunctioning. Change the valve. * The safety valve itself could be faulty. Change it. * The speed regulator rod might be improperly adjusted. Re-adjust it by elongating.
D
Danny SchneiderAug 28, 2025
What causes insufficient free air delivery in my AirMan Air Compressor?
- C
  cindy30Aug 28, 2025
  Insufficient free air delivery can be due to: * A clogged air filter element. Clean or change the element. * The unloader valve not fully opening. Call your nearest dealer. * The engine not reaching rated speed. See section 6.1.
E
Emily KelleyAug 31, 2025
Why does the revolution drop before the discharge air pressure reaches 100 psi (6.9 bar) in my AirMan Air Compressor?
- J
  Jessica WrightAug 31, 2025
  The revolution may drop before the discharge air pressure reaches 100 psi (6.9 bar) due to: * Insufficient adjustment of the pressure regulator. Re-adjust it by fastening. * Trouble with the pressure regulator. Change it. * A clogged unloader orifice. Disassemble and check it.
D
davidtaylorSep 4, 2025
Why isn't my AirMan PDS185S-6B4 Air Compressor discharge air pressure reaching 100 psi (6.9 bar)?
- S
  Sandra IrwinSep 4, 2025
  If the discharge air pressure isn't reaching 100 psi (6.9 bar), it could be due to: * Insufficient adjustment of the pressure regulator. Re-adjust it by fastening. * The starting unloader valve being left at its start position. Place it at the “RUN” position.
E
Eileen PerrySep 7, 2025
What causes the engine of my AirMan Air Compressor to not reach minimum revolution at unload?
- R
  Rebecca HansenSep 7, 2025
  If the engine does not reach minimum revolution at unload, it could be due to: * Improper length in the speed regulator rod. Re-adjust it. * A faulty speed regulator. Disassemble and check it.
N
Nicholas MclaughlinSep 12, 2025
How to troubleshoot low starter revolution speed on my AirMan PDS185S-6B4 Air Compressor?
- S
  Stephen HolmesSep 12, 2025
  A low starter revolution speed could be caused by a battery malfunction. Check the battery; charge or change it as necessary.