Revision 12.2
Jan. 2016
15 / 61
3 OPERATION
3.1 General
In the normal operating mode in which the turning knob always is
connected to the volume (VOL). The normal operating mode can be left by
pressing the AUD, FREQ or MEMORY button.
When not in the normal mode and there is no pilot action for more than 10
seconds the unit returns to the normal mode.
3.2 ON / OFF Switching
ON / OFF switching is done by pushing the self-locking switch.
After power up the following display will be displayed:
Device-name
KRT2
Software-
Version e.g. V8.2
(example)
The unit then starts in the normal operating mode using and displaying the
data last used.
To Next Page
Loading...