Maintenance
8-6 2021 Classic
Tire Load and Ination Information
Maintaining proper tire ination pressure is essential for
both tire safety and performance.
Proper Tire Ination
The level of air in your tires affects your vehicle’s
overall performance. A maximum ination pressure
specication is found on the trailer’s exterior on a metal
tag riveted to the lower front, roadside of the trailer, as
well as on the original equipment tires.
Air pressure should be checked based on the load on
each individual tire. Cold Ination Pressure should be
adjusted to handle the maximum tire load, and all tires
on the axle should carry the same ination pressure.
Cold tire ination pressure is the tire pressure checked
in the morning before you drive more than a few miles,
or before rising ambient temperatures or the sun’s
radiant heat affects it.
Under Inated Tires
Under ination brings a higher risk of damage due to
road hazards, reduces casing durability, causes a loss
in fuel economy, and will result in uneven or irregular
tire wear. Severe under ination brings about an
increased risk of tread separation, handling difculties,
and possible tire failure, caused by overheating.
When minimum ination pressure requirements are not
met, tire durability and optimum operating conditions
are compromised. Tire ination pressure should always
meet the guidelines for vehicle weight.
Observe the following:
• It may be necessary to inate your tires at a truck
stop or truck service center in order to achieve
adequate air pressure for your trailer’s needs.
• Only permanent air seal metal valve caps should be
used.
• Be safe - if a tire has been run in a 20% under
inated condition, it must be dismounted and
inspected by a trained professional. It should not be
aired up without a full inspection or without using a
safety cage. Use a calibrated gauge. If your tire is
rated for higher ination pressures, a special gauge
will be required designed for larger tires.
• Do not bleed air from warm tires to reduce pressure
buildup.
• Do not inate tires to cold psi rating beyond rim
specications.
How Overloading Affects Your Tires
Tire pressure is what enables your trailer tire to
support loads, thus, overloading can have serious
consequences. Too much weight can cause stress
on the suspension system components, brake failure,
handling and steering problems, irregular tire wear, and
possible tire failure. If you discover your tires cannot
handle the load, lighten the weight of the load on your
tires.
Weighing Your Trailer Or Towed Vehicle
Since a trailer or towed vehicle adds to the load on
the tires, it is crucial to properly weigh towed vehicles.
Refer to Section 7 - Towing section for important
detailed information on loading and weighing of the
trailer�
Tire Care
The most important function of tires is to provide
traction while moving and grip when steering or
stopping. The tires on your trailer are designed for
highway use and must be properly maintained in order
to maximize tire life, as well to provide a safe mode of
transportation.
Tire Care Tips
To reduce the risk of tire failure, we strongly
recommend the following:
1� Check the pressure in your tires, including your
spare, at least monthly when the tires are cool
(after the vehicle has been stopped for three
hours and then driven less than one mile). Do not
reduce pressure when tires are hot. Use a tire
gauge to check pressure and maintain it at the
recommended level.
2� Never overload your tires. Heed the maximum
load-carrying capability of your tires.
3� Check your tires frequently for scrapes, bulges,
separations, cuts, or snags resulting from use. See
your tire dealer immediately if any such condition is
discovered.
4� Never operate your vehicle in excess of lawful
speeds, the maximum speeds justied by driving
conditions, or in excess of speeds recommended
for the tires you are using.
5� Make every effort to avoid running over objects
that may damage the tire through impact or cutting,
such as chuck holes, glass, metal, etc.
To Next Page
Loading...
