AirTools Voice Processor 2x - Page 15

15
Voice Processor 2x
2xNetworking
If you are on your own private network, directly or indirectly
connected to the 2x, you may allow the 2x to choose an
automatic IP address or you may choose to assign it a static
IP address. If you are building your own separate network
with static assigned addresses, you may consider using an
IP Address from one of the ”Private-Use” networks noted in
RFC-1918:
1.172.16.0.0/12=IPAddresses172.16.0.1through
172.31.254.254andaSubnetMaskof255.240.0.0
2.192.168.0.0/16=IPAddresses192.168.0.1through
192.168.254.254andaSubnetMaskof255.255.0.0
3.10.0.0.0/8=IPAddresses10.0.0.1through
10.254.254.254andaSubnetMaskof255.255.0.0
Connecting to the 2x through a Firewall/VPN
We have successfully tested control of a 2x through a firewall
andVPN,butareunabletoguaranteeperformanceofthese
types of connections at this time. Configuration instructions
arespecictoeachrewallandVPN,sospecicsarenot
available. Additionally, wireless communications are also not
guaranteed, though have also been successfully tested.
Configuring your computer for a network
connection: Windows
®
XP
1.Select“Start->ControlPanel”.
2.Openthe“NetworkConnections”ControlPanel.
3.Rightclickonyour“LocalAreaConnection”andselect
””Properties”.
4. Under “This connection uses the following items”, select
“Internet Protocol (TCP/IP)” and press “Properties”.
Router/Firewall
IP: 10.0.0.1
Switch
Host Computer & PC LAN
IP: 10.0.0.3
SM: 255.255.0.0
GW: 10.0.0.1
Voice Processor 2x
IP: 10.0.0.2
SM: 255.255.0.0
GW: 10.0.0.1
Ethernet
Ethernet
to Internet