AirTools Voice Processor 2x - Software Installation and Launch; Installing the Voice Processor 2 x Software

6408 216th Street SW | Mountlake Terrace, WA 98043 USA
T +1.425.778.7728 F +1.425.778.7727 | www.SymetrixAudio.com
18
Quick Start Guide
Voice Processor 2x Software
Installation
The Voice Processor 2x software provides real-time set-up
and control from a Win dows PC environment.
Use one of the following procedures to install the Voice
Processor 2x software on your computer.
FromtheCD-ROM:
1.InserttheCDintoyourcomputer’sCD-ROMdrive.
2.Open“MyComputer”.The“MyComputer”iconis
typically on your desktop or in the “Start” menu.
3.DoubleclickonyourCD-ROMdrive.Thisistypicallydrive
“D:\”.IfyourCD-ROMdriveisn’t“D:\”,thensubstituteits
drive letter.
4. Double-click “Setup.exe”.
From the Symetrix web site (http://www.SymetrixAudio.com):
1. Download the Voice Processor 2x software installer from
the Symetrix web site.
2. Double-click on the file you just downloaded and follow
the on screen directions to install.
The software always starts up in offline mode. Regardless,
you can explore the software, experiment to your heart’s
content, and perhaps even get useful work done. You can
save any device files that you create to your hard drive and
transfer them to hardware later.
After installing the software, browse the rest of the Help File,
or move on to the Connection Wizard to get connected to
your 2x.
Launch the software
You can launch the Voice Processor 2x software via either
theStartMenuortheDesktopicon.Oncelaunched,the
Voice Processor 2x software presents the following options:
YoumaychoosetocreateaNewFileusingthefactory
default settings.
If you choose to open an Existing File on Computer, a list
ofrecentlyusedlesispresented.ABrowsebuttonisalso
available to manually locate the file of your choosing from a
local drive or network share.
If you choose to open an Existing File on Device, a list of
recently connected-to devices is presented. An “Open
Connection Wizard” choice is also available in the event that
you are unsure of which device to connect to or your device
is not listed among the recently connected to devices.
After installing and launching the software and choosing your
operating mode above, you may browse the rest of the Help
File, or move on to the Connection Wizard to get connected
to your 2x.
Connection Wizard
Once you have completed the Hardware Connections and
connectedyournetwork(refertoNetworkConguration),
you may open the 2x Application and run the Connection
Wizard.
The Connection Wizard can be run by clicking on its icon in
the toolbar...
...or from the Tools menu:
SoftwareInstallation•ConnectionWizard