14
The App allows you to configure the key repeat rate, power saving
settings, select pairing method and configure the signals for each
of the pedals in each mode.
If any firmware updates are available, you will be notified after
the App has connected. After performing the update, the PEDpro
will install it and restart. Remove the pairing from your
iOS/Android/PC/Mac device, power on the PEDpro, and
reconnect.
UNIT IDENTIFICATION
The unit name in your Bluetooth host consists of several codes to
help with support and identifying your specific device. For
example:
PEDpro v2.1.0 ABCD
V2.1.0 refers to the firmware number.
ABCD refers to the MAC address.
This is helpful if there are many PEDpro units in the same location.
Your MAC address will always be the same so you can easily
identify your unit. You will find your specific MAC address
labeled on the bottom of your PEDpro at the end of the serial
number.
To Next Page
