Name: Airwell DLSE Series
Brand: Airwell
Rating: 4 (1 reviews)

To Next Page

To Previous Page

14-13

SERVICING

SM DLSDCI 3-A.1 GB

14.2.9 Removing Thermistors

1. Disconnect the thermistor connector from the main board.

2. Cut the nylon ties holding the wires to the pipes or chassis.

ICT thermistor only - Pull up the spring from the housing while pulling out the thermistor.

Notes for re-assemble the ICT thermistor:

1. Make sure the spring is inserted rst and is facing the tube to be attached to. Hold the thermistor

wires to the tube with nylon tie holding both the wires and the protective sleeve

14.2.10 Removing Float Switch

1. Disconnect the wire to wire oat switch connector

inside the unit.

2. Cut the nylon ties holding the wires to the pipes or

chassis.

3. Remove the screw holding the switch holder to

the unit chassis.

4. Use two open spanners to remove the nylon nuts

of the switch and take out the switch.

Removing Thermistor

Removing Coil Thermistor

Removing Float Assembly

Indoor Air Thermistor (RAT) Indoor Coil Thermistor (ICT)

Questions and Answers:

Need help?

Do you have a question about the Airwell DLSE Series and is the answer not in the manual?

Airwell DLSE Series Specifications

General