- 8 -
Press the speed up button, the LED lights of speed
indicator will be on one by one.
Press the speed down button, the LED lights of speed
indicator will be off one by one.
It shows the percentage of the remaining battery capacity.
Each LED light represents 20% of the battery capacity. The
LED lights will be off one by one after consumed every 20%
of the battery. For example, it means 40% battery consumed
already when two LED lights are off. Better charge the battery
when 2 or 3 LED lights are off to prolong the battery life. It is
prohibited to drive the wheelchair when there is only one LED
light on, otherwise, it will cause damage to the battery due
to over-discharge. The accuracy of the power indicator will
decrease after daily use.
Speed indicator
5-level LED power indicator
In the power-off state, press the button over 2 seconds,
the H3T enters the extending/contracting mode.
Release it to extend.
In the extending/contracting mode, click the button
to stop extending if it is extending. When contracting
stops, click it to extend.
In the ready mode, remote control mode and riding
mode, click the gear button to increase one gear.
In the extending/contracting mode, click the button to stop
extending or contracting. It enters the shutdown state.
Speed up / Unfold
Stop folding / unfolding
Shutdown state: the circuit connection is complete, the power switch in the battery pack is turned on. But the on-off
button in the control box isn't pressed and the indicator light isn't on.
Standby state: press the on-off button in the control box, the indicator light will be on, but without any man-made
operation.
Riding state: press the on-off button in the control box, the indicator light will be on, and use the operating lever to
make it move.
To Next Page
Loading...
Need help?
General
