MANUAL TUNING
1
Press the TUNER button repeatedly to select the
desired band.
FM AM
If the power is turned off, the previously tuned station will be
played (Direct Play Function).
2
Press the TUNING UP or DOWN button to select
a station.
Each time the button is pressed, the frequency changes.
When a station is received, “TUNE” is displayed for 2 seconds.
During FM stereo reception, 1 is displayed.
To search for a station quickly (Auto Search)
Keep the TUNING UP or DOWN button pressed until the tuner
starts searching for a station. After tuning in to a station, the
search stops.
To stop the Auto Search manually, press the TUNING UP or
DOWN button again.
• The Auto Search may not stop at stations with very weak
signals.
RADIO RECEPTION
When an FM stereo broadcast contains noise
Press the REPEAT/MONO TUNER button so that “MONO”
appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button so that MONO
disappears.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press the POWER button while pressing the TUNER button.
To reset the interval, repeat this procedure.
When the AM tuning interval is changed, all preset stations (see
“PRESETTING STATIONS”) are cleared. The preset stations
have to be set again.
9
ENGLISH
MONO
To Next Page
Loading...
