HDP3 Mini-Converter v1.0 www.aja.com
10
Installation
Typically, HDP3 installation consists of the following steps:
1. Ensure the converter is disconnected from power.
2. Connect video equipment to the converter BNC and DVI connector.s
3. Connect audio equipment to RCA connectors (optional)
4. Apply power to the converter (AJA power supply included).
5. The converter will now run using the default factory settings. If you wish to alter the
factory settings, you’ll need to:
• Install the AJA Mini-Config software on your computer
• Attach the converter via USB
• Make your changes using Mini-Config setup screens.
• This process is detailed in “USB Control and Setup—Using AJA Mini-Config” on
page 11.
To Next Page
Loading...
