Installation
Before installing the detector, make sure that you have selected the optimal location and
it is in compliance with the guidelines contained in this manual!
KeyPad should be attached to the vertical surface.
As soon as the KeyPad is fixed in SmartBracket, it will blink with the LED
X(Fault) — this will be a signal that the tamper has been actuated.
If the malfunction indicator
Xdid not blink after installation in SmartBracket,
check the status of the tamper in the and then check the fixing
tightness of the panel.
If the KeyPad is torn off from the surface or removed from the attachment panel,
you will receive the notification.
Jeweller Signal Strength Test
Attenuation Test
1. Attach the SmartBracket panel to the surface using bundled screws, using
at least two fixing points (one of them — above the tamper). After selecting
other attachment hardware, make sure that they do not damage or deform
the panel.
The double-sided adhesive tape may be only used for temporary attachment of
KeyPad. The tape will run dry in course of time, which may result in the falling of the
KeyPad and damage of the device.
2. Put KeyPad on the attachment panel and tighten the mounting screw on the
body underside.
Ajax app
To Next Page
Loading...
Need help?
General
