Operating Principle
KeyPad is a touch keypad for managing the Ajax system. It controls the security
modes of the entire object or individual groups and allows activating the Night
Mode. The keyboard supports the “silent alarm” function — the user informs the
security company about being forced to disarm the security system, and is not
exposed by the siren sounds or Ajax apps.
You can control the security modes with KeyPad using codes. Before entering
the code, you should activate (“wake up”) the keypad by touching it. When it is
activated, the button backlight is enabled, and the keypad beeps.
KeyPad supports code types as follows:
The number of personal codes and access codes depends on the hub model.
The brightness of the backlight and the volume of the keypad are adjusted in its
. With the batteries discharged, the backlight turns on at the minimum
level regardless of the settings.
If you do not touch the keypad for 4 seconds, KeyPad reduces the brightness of
the backlight, and 8 seconds later goes into power-saving mode and turns off
the display. As the keypad goes into power saving mode, it resets the
commands entered!
KeyPad supports 4 to 6 digit codes. Entering the code should be confirmed by
pressing one of the buttons: (arm), (disarm) (Night Mode). Any
Keypad Code — general code that is set up for the keypad. When used, all
events are delivered to Ajax apps on behalf of the keypad.
User Code — personal code that is set up for users connected to the hub.
When used, all events are delivered to Ajax apps on behalf of the user.
Keypad Access Code — set up for a person who is not registered in the
system. When used, events are delivered to Ajax apps with a name
associated with this code.
settings
To Next Page
Loading...
Need help?
General
