Remember to check the signal strength at the installation site. If the signal
strength is low (a single bar), we do not guarantee a stable operation of the
security system!
If the detector has low signal strength, take whatever action is possible to
improve the quality of communication! At a minimum, relocate the device:
repositioning by even 20 cm can significantly improve the reception quality.
Detector Installation
Before installing the detector, make sure that you have chosen an
appropriate location as indicated in this manual.
The recommended height of the installation is 2.4 m. If the detector is not
installed at the recommended height, this will reduce the area of the motion
detection zone and disrupt the operation of the pet immunity function.
Use the SmartBracket mounting panel to mount the MotionCam detector on
a vertical surface or in a corner. SmartBracket has special recesses for
fixing it with the bundled screws.
To Next Page
Loading...