Functionality Testing
Ajax security systems can run tests to verify the functionality of connected
devices.
The tests do not start immediately but within 36 s under default settings.
The test start delay depends on the detector polling period settings (see
Jeweller settings section in hub settings).
The tests are available in the detector settings menu:
● Jeweller Signal Strength Test
● Wings Signal Strength Test
● Detection Zone Test
● Attenuation Test
If any interference is detected or the signal strength is too low to transmit
images, the user will receive a push notification “High interference at
Wings frequencies”.
Detector Placement
The location of the detector directly affects the efficiency of the security
system. The location of the MotionCam detector is determined by its
distance from the hub and presence of any obstacles between the devices
To Next Page
Loading...