4. Turn on the device by holding its power button for 3 seconds. Please
note that the hub connection request is only sent for a short time while
switching on the device.
For detection and pairing to occur, the device must be within a hub’s
wireless coverage (at the same facility).
MotionCam turns off automatically within 6 seconds after activation if it fails
to connect to the hub. There is no need to turn off the device to retry.
If the device has already been paired with another hub, turn MotionCam off,
and then follow the standard pairing procedure.
After pairing, the detector will appear on the app’s hub device list. The
frequency of the device status updates depends on the polling interval
indicated in the hub’s settings (36 seconds by default).
To Next Page
Loading...