English   - 76 -
Safety Information
CAUTION
DVD Player is a class 1 laser product. However this 
product uses a visible laser beam which could cause 
hazardous radiation exposure. Be sure to operate the 
player correctly as instructed.
CLASS 1  
LASER PRODUCT
RISK OF ELECTRIC SHOCK
The lightning flash with arrowhead 
symbol, within an equilateral triangle, is 
intended to alert the user to the presence 
of uninsulated “dangerous voltage” within 
the product’s enclosure that may  be of 
sufcient magnitude to constitute a risk 
of electric shock of persons.
The  exclamation  point  within  an 
equilateral triangle is intended 
to alert the user to the presence of 
important operating and maintenance 
(servicing) instructions in the literature 
accompanying the appliance.
Notes on Discs
On handling discs
• To keep the disc clean, handle the disc by its edge. 
Do not touch the surface.
• Do not stick paper or tape on the disc.
• If the disc is contaminated with any substance like 
glue remove before using it.
•  Do  not  expose the disc to  direct  sunlight  or  heat 
sources such as hot air ducts, or leave it in a car 
parked in direct sunlight as the temperature can rise 
quickly and damage the disc.
• After playing, store the disc in its case.
On cleaning
• Before playing, clean the disc with a cleaning cloth. 
Wipe the disc from the center out.
•    Do  not  use  solvents  such  as  benzine,  thinner, 
commercially available cleaners or anti-static spray 
intended for vinyl LPs.
Licence Notication
•  This  product  incorporates  copyright  protection 
technology that is protected by U.S. patents 
and other intellectual property rights. Use of 
this copyright protection technology must be 
authorized by Rovi Corporation, and is intended for 
home and other limited viewing uses only unless 
otherwise authorized by Rovi Corporation. Reverse 
engineering and disassembly are prohibited.
How to Watch a DVD
When placing a disc into the loader, labeled side of 
the disc should be on the front:
When TV set is turned on, rst switch to DVD source 
by using the SOURCE button on the remote control. 
Press play on the remote control, or directly press play 
button at the front panel. If there is no disc inside the 
loader,  place a DVD rst and press play.