English - 51 -
Connect the PC cable between the PC INPUT on the TV and the PC output on your PC.
Note: You can use YPbPr to VGA cable (not supplied) to enable YPbPr signal via VGA input.
WARNING: You cannot use VGA and YPbPr at the same tim
5. SPDIF Out outputs audio signals of the currently watched source.
Use an SPDIF cable to trasfer audio signals to a device that has SPDIF input.
6. DC 12 V Input is used for connecting the supplied power adaptor.
.
Viewing the Connections - Side Connectors
1. The CI Slot is used for inserting a CI card. A CI card allows you to view all the channels that you
subscribe to. For more information, see “Conditional Access” section.
2. Side USB input.
3. Video Input is used for connecting video signals of external devices.Connect the video
cable between the VIDEO IN socket on the TV and the VIDEO OUT jack on your device.
4. Audio Inputs are used for connecting audio signals of external devices. Connect the audio
cable between the AUDIO INPUTS on the TV and the AUDIO OUTPUT jacks on your device.
Note: If you connect a device to the TV via the VIDEO INPUT, you should also connect your
device with an audio cable to the AUDIO INPUTS of the TV to enable audio.
5. The headphone jack is used for connecting an external headphone to the system.
Connect to the HEADPHONE jack to listen to the TV from headphones.
6. Volume/ Programme/ Source and Standby-On switch
To change volume: Increase the volume by pushing the button up. Decrease the volume
by pushing the button down.
To change channel: Press the middle of the button, the channel information banner will
appear on screen. Scroll through the stored channels by pushing the button up or down
To change source: Press the middle of the button twice, the source list will appear on
screen. Scroll through the available sources by pushing the button up or down.
To turn the TV off: Press the middle of the button down and hold it down for a few seconds, the TV will
turn into standby mode.
Power Connection
IMPORTANT: The TV set is designed to operate on 12 V DC. For this, an adaptor is used which gives
12 V voltage. Connect this adaptor to a system that supplies 110-240V AC,50/60Hz.
• After unpacking, allow the TV set to reach the ambient room temperature before you connect the set to the
mains.
To POWER
INPUT DC 12 V
terminal
AC adapter
H MD I 1
SPDIF
Coax.OUT
12V
DC IN
To Next Page
Loading...
