Akai AP-D33

3. AUTO-RETURN ADJUSTMENT
AUTO-RETURN
ADJUSTMENT SCREW
AUTO-RETURN
ADJUSTMENT ——
GROOVE
AUTORETURN ADJUSTMENT SCREW CAP
Fig. 8 Auto-Return Adjustment
1) Leave the Power Cord connected for easy con- return adjustment is successful.
formation of adjustment, and return the Tone If no clicking is heard, repeat the procedure until
Arm to Tone Arm Rest. it is.
2) Remove the Aut-return Adjustment Screw cap. * Turning the screw 90° clockwise moves the
3) Adjust the Auto-return Adjustment Screw. position of Stylus approx. 4.5mm towards the
4) Put the Tone Arm just over the Groove for Auto- Spindle. Turning 90° counterclockwise moves the
return Adjustment in the rubber mat. position of Stylus approx. 4.5 mm away from the
5) Listen for a clicking which indicates that the auto- Spindle.
4. ARM LIFTER ADJUSTMENT
ARM LIFTER
ELEVATION LEVER(A)
Yr ELEVATION
KNOB
ELEVATION
SHAFT
Tu Vv
ELEVATION LEVER(B) SCREW(a) BEM
Fig. 9
20