Akai AP-D40

4. RETURN PLUNGER POSITION ADJUSTMENT
REJECT
PLATE
GAP A
PLUNGER
SL9OI REJECT LEVER
ADJUST MENT.
SCREW
Fig. 19
Remove the motor block. Press the reject lever down where the gap A between the reject lever and plunger
with a finger until the reject plate touches the main disappears. (Refer to Fig. 19).
gear pin. Operate the plunger (SL901) in this position After adjustment, confirm that the Auto-Return is
and adjust the installation screw at exactly the point operating.
5. LEAD-IN/LEAD-OUT ADJUSTMENT
LEAD-IN/LEAD-OUT ADJUSTMENT
SCREW CAP _
Fig. 20 Lead-in/Lead-out Adjustment
a
21