EQ
ON/STAND-BY
ENGLISH
Tuning
oo
oooo
/
/
/
Radio
Listening to the radio
When radio interference occurs, auto scan tuning may stop automatically at that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING button again.
" " will appear when an FM broadcast is in stereo.
If the FM reception is weak, press the TUNER/BAND button to extinguish the "ST" indicator. The
reception changes to monaural, and the sound becomes clearer.
1 Press the ON/STAND-BY button to turn the power on.
2 Press the TUNER/BAND button repeatedly to select the
desired frequency band (FM or AM).
3 Press the TUNING (
or ) button to tune in to the desired
station.
Manual tuning:
Press the TUNING button as many times as required to tune in
to the desired station.
Auto tuning:
When the TUNING button is pressed for more than 0.5
seconds, scanning will start automatically and the tuner will
stop at the first receivable broadcast station.
Note:
This product can receive FM stereo/FM monaural and AM monaural broadcast. AM stereo broadcasts
will not be played in stereo.
Press the TUNER/BAND button to display the "ST" indicator.
Notes:
To receive an FM stereo transmission:
FM stereo receiving indicator
FM stereo mode indicator
ST
MHz
PAUSESTOP/EJECTF.FWDREWINDPLAYRECORD
TAPE
68
PAUSESTOP/EJECTF.FWDREWINDPLAYRECORD
ON/
STAND-BY
TUNER/
BAND
FOLDER/TUNING
PRESET
To Next Page
Loading...
