EN-ENGLISH
1. Lock catch
2. Dust cover
3. 45rpm adaptor
4. Speed selection - Three
speed for choice: 33, 45,
78 rpm
5. Auto stop control
6. Carrying handle
7. Detachable leg
8. SD card connector
9. USB connector
10. Mode: REC/USB/SD/Bluetooth /Bluetooth out selection button
11. Next music
12. Pause/play button/DEL
13. Previous music
14. Aux-in
15. Line out R channel
16. Line out L channel
17. DC power jack
INITIAL SET-UP
MAIN CONNECTIONS
Ensure that the mains voltage of your home corresponds to the operating voltage of the
unit. Your unit is ready to be connected to a mains voltage of 5V DC adaptor.
CONNECTING TO AN EXTERNAL SOUND SYSTEM
Should you wish to connect the turntable to an external amplifier follow the below steps.
Connect an RCA audio cable (not supplied) to the AUDIO LINE OUT sockets on the rear
of the turntable.
Note: Take care to match the RED/WHITE plugs to the corresponding RED/WHITE sockets.
Connect the other end of the cable to an AUDIO INPUT on the amplifier (check your
amplifier user manual if you are not sure).
The volume control on the turntable will have no effect on the volume level when
connected this way. All volume controls should be operated from the amplifier.
Note: Turn the volume on the turntable all the way down, so it does not interfere with the
external sound system.
Playing a record
Before use, ensure the security wire (tone-arm rest/lock) and the cartridge protector
(stylus/cartridge) have been removed. And the tone-arm lock is released.
Place a record on the turntable platter.
Select the speed required using the speed selector switch.
Raise the tone-arm using the tone-arm lift lever. As you move the tone-arm towards
the record the turntable begins spinning. Lower the needle gently onto the outer edge
of the record using the tone-arm lift lever.
Rotate the ON/OFF/Volume control knob to increase or decrease the volume level.
When a record comes to the end, the turntable will stop automatically if the auto-stop
switch is in the “ON” position
If the switch is in the off position then it will keep revolving all the time.
To Next Page
Loading...
