EN-ENGLISH
Lift up the tone arm and put it on the rest when finished.
Replace the protective cap on the stylus and close the tone arm lock.
Turn off power at mains.
USB flash drive and SD card reader Recording
(Lift up the tone arm and put it on the rest.)
LISTEN TO MUSIC:
If you want to play music from your installed SD card or USB flash memory, turn the
power & volume control knob clockwise to power on; the music will start playing
automatically.
You can play or pause music by pressing the play-pause/Del button.
If you want to play the next or previous track from your installed SD card or USB flash
memory, press the next track or previous track button.
If you have installed an SD card & USB flash memory, the last one installed will start
playing. You can select the desired source by pushing the MODE/REC button. (SD =>
USB). The mode button will select the active/installed sources only. Only mp3 file
format is supported.
Note: the tone arm must be in rest position.
RECORDING MUSIC:
You can convert your vinyl records into digital mp3 files by inserting an SD/MMC card in
the SD/MMC card reader slot or USB flash memory device into the USB port.
Play your ‘vinyl’ music, as described in ‘listening to a record’.
Press and hold the MODE/REC button for 2 seconds.
You will hear one ‘short beep’, indicating that recording has started.
When finished recording, press “MODE/REC” for 2 seconds to stop recording.
You will hear 2 ‘short beeps’, indicating that the recording has stopped.
The recorded songs will be saved in the “RECORD” folder as mp3 file, in 128 kbps.
Long press the MODE/REC button, you can switch to the “RECORD” folders to play the
recorded music.
DELETE RECORDED MUSIC:
If you want to delete the song being played from your USB flash memory or SD/MMC
card, long press the play-pause/Del button. You will hear 2 “short beeps” confirming that
the song being played has been deleted.
Bluetooth function
（Lift up the tone arm and put it on the rest）
Press “MODE/REC” button to select Bluetooth mode.
Open up your Bluetooth settings and search for “ATT-100BT” to connect.
A sound prompt will indicate connection.
Under this function, turntable function will be stopped automatically.
Bluetooth out function
Rotate the ON/OFF control knob, and thrice click the Mode button, the Bluetooth
indicator will flash blue quickly.
Place a record on the turntable platter, or insert a SD/MMC card in the SD/MMC card
reader slot or USB flash memory device into the USB port.
To Next Page
Loading...
