Normal operation
FM Antenna
While in FM mode, tune into any FM station and extend the antenna to find a position that provides
the best reception. The antenna may need to be re-positioned if you move the unit to a new location.
DC Power Adaptor
Plug the DC power adaptor into a socket.
How to set up the time
• Plug the adaptor, the LED indicator will show 00:00 o’clock automatically.
• Long press the PROG button can enter into clock setting. Press the NEXT/PREVIOUS buttons ( /
) to adjust the clock. Short press the PROG button to finish this step. Long press the Mode button
can switch the clock system (00:00/12:00).
How to restore factory settings
• Long press the REPEAT button for 5 seconds can restore factory settings.
Playing a Record
Important: To avoid stylus damage, make sure the included stylus guard is in place whenever the
turntable is being installed, moved and cleaned.
• Turn On the unit and adjust the volume
to an appropriate level.
• Press the Mode button to the PHONO
function.
• Place a record on the turntable platter
and select the correct player speed: 33 1/3,
45, 78 RPM according to the vinyl being
played. When playing a 45 RPM record, use the included 45 adaptor.
• Set the auto/manual stop control: Set the Auto Stop switch to ON if you are playing a 33 RPM
record and you want the turntable to stop turning when the record is finished. If the auto stop switch
is set to OFF, the turntable will continue turning.
• Remove the stylus guard and unlock the Tone Arm lock.
• Push the Lift Lever up to raise the Tone Arm and then gently move the Tone Arm to the desired
position over the record. The platter will begin to spin when the Tone Arm is moved toward the
record. Push the Lift Lever forward to lower the Tone Arm slowly onto the desired position on the
record. The record will begin playing.
• When the record is finished, push the Lift Lever backwards to raise the Tone Arm and gently move
it back to its rest position.
To Next Page
Loading...
