• When you have finished playing records, engage the Tone Arm lock to protect it from accidental
movement. Press the Power off button to switch the unit OFF. Unplug it from the power supply if it is
not going to be used for a while.
NOTE:
1. This unit is designed with AUTO STOP function for the PHONO. With this function ON, the vinyl
record will stop automatically when it plays to the end.
2. AUTO STOP function applies to most 33RPM vinyl records. However, even if the AUTO STOP
function is ON, it may happen that some vinyl records, e.g. 45RPM, will stop before playback comes
to the end OR will not stop automatically when playback comes to the end. If the vinyl record stops
before playback comes to the end, set the AUTO STOP switch to "OFF" position. Then playback will
continue, but it will not stop automatically.
Playing a CD
• Turn the unit ON by pressing the Power button.
• Turn the Volume knob to adjust the volume.
• When power on, the turntable is in CD mode.
• “- -” will blink for a few seconds. When no disc is loaded, “no” will appear on the LED display screen.
• Place a disc on the tray with the printed label upward. Do not place more than one disc in the tray
at a time.
• Press the OPEN/CLOSE button ( ) to open/ close the tray. Do not force the tray by hand when it
is opening or closing.
• The system will start playback automatically after several seconds, or press the PLAY/PAUSE button
( ) to start playback.
• Press the button to play the previous or next track.
• Press the PLAY/PAUSE button ( ) to start/pause playback. Press the STOP button (■ ) to stop
playback.
• During playback, press the REPEAT button once to repeat a single track. Press the REPEAT button
twice to repeat all tracks.
• In STOP mode, short press PROG button to enter program. The display will show “P01” and blink,
press ( / ) to select a track and press the PROG button again to save the track. Repeat this
step to save the tracks you want. Press the PLAY/PAUSE ( ) button to play back the PROG med
tracks. Press the STOP ( ■ ) button twice to erase the PROG med track.
Playing the Radio
• Turn ON the unit and adjust the volume to an appropriate level.
• Press the Mode button to the TUNE position.
• Extend the antenna to obtain the best reception.
• Long press the PLAY/PAUSE ( ) button to search the stations automatically. Long press the (
/ ) to search the station semi-automatically.
• Press the MEM- or MEM+ to choose your desired radio station.
• Short press PROG button to enter program. The display will show “P01” and blink, press (MEM- /
MEM+ ) to select a station and press the PROG button again to save the station. Repeat this step to
save the stations you want.
Bluetooth playing
• Press the Mode button to switch the Bluetooth function and turn the volume to moderate.
• Open your Bluetooth device, search “ATT-14BT” to connect.
• Connected if there is a reminding sound, and the “bt” will show on the LED display.
• Press the / button to play the previous or next track
To Next Page
Loading...
