Akai CR-80-SS User Manual

VOLTAGE AND CYCLE CONVERSION
Fig. 3
Fig. 4
*
I
V „o* s
Fig. 5 Fig. 6
Fig. 7
Fig. 8
FRONT
INPUT SELECTOR
r-LINE INPUT -i
REC/PB
LINE OUTPUT
RIGHT
RIGHT
VOLTAGE
With the built-in stepdown power transformer, Model
CR-80-SS (CR-80D-SS) is operable anywhere in the world. The
operator can easily readjust the recorder to any one of the six
stages of power voltage from 100 to 240 volts AC. The
operator is requested to check the recorder to determine the
previously set voltage before operation.
If another voltage is required, readjustment can be made as
follows:
(1) Remove the FUSE POST as shown in Fig. 3. Remove the
VOLTAGE SELECTOR PLUG and reinsert to desired
voltage.
(2) Change the fuse according to voltage. Fuse: 100 V-120 V
2 A; 200 V-240 V 1 A
CAUTION: Disconnect power plug from AC outlet before
readjusting voltage. To maintain optimum performance
and prolong the life of your machine, it is important that
the line voltage be held within a 10 percent deviation of
standard area voltage.
CYCLE
Correct tape speed cannot be obtained if the CYCLE
CONVERSION SWITCHES are not properly positioned.
CYCLE CONVERSION SWITCH (A) is located on the rear
panel and CYCLE CONVERSION SWITCH (B) is located on
the bottom of the recorder. Set CONVERSION SWITCH (A)
to correspond with area voltage. With a screw driver, set
CONVERSION SWITCH (B) accordingly. For 60 cycles, turn
screw clockwise. For 50 cycles, turn screw counter-clockwise.
Caution: Operate CYCLE CONVERSION SWITCHES only
when recorder is in PLAY MODE.
JC8
- GROUND (common to both channels)
-PREAMP OUTPUT (left channel-recorder)
-PREAMP OUTPUT (right channel-recorder)
-GROUND (same as number 8 above)
- REC INPUT (right channel-ext. amp)
-REC INPUT (left channel-ext. amp)
Front View of DIIM JACK
4
Fig. 9
Fig. 10

Akai CR-80-SS Specifications

General

Brand	Akai
Model	CR-80-SS
Category	Measuring Instruments
Language	English