Akai CS-705D

|. TECHNICAL DATA
TRACK SYSTEM
TAPE SPEED
WOW AND FLUTTER
FREQUENCY RESPONSE
DISTORTION
SIGNAL TO NOISE RATIO
ERASE RATIO
BIAS FREQUENCY
HEADS
MOTOR
FAST FORWARD AND REWIND TIME
OUTPUT JACKS
INPUT JACKS
DIN JACK
TRANSISTOR
IC
DIODE
POWER REQUIREMENTS
4 track 2 channel stereo system
1-7/8 ips:
Less than 0.08% WRMS (NAB)
Less than 0.24% (DIN 45507)
35 to 14,000 Hz +3 dB using Low Noise tape
35 to 15,000 Hz +3 dB using Chrome tape
35 to 16,000 Hz +3 dB using Fe-Cr tape
Less than 1.5% using Low Noise tape (1,000 Hz ‘‘0” VU)
Better than 51 dB (measured via tape with peak recording
level of +3 VU)
Dolby Switch ON: Improves up to 10 dB above 5 kHz
Better than 70 dB
85 kHz
(2): One Recording/Playback Head, One Erase Head
(1): Electronically Speed Controlled DC Motor
80 sec using a C-60 cassette tape
Line(2): 410 mV (“0” VU)/Required load impedance: more than 20 k ohms
Phone (1): 50 mV/8 ohms
Microphone(2): 0.3 mV/Required microphone impedance: 600 ohms
Line(2): 70 mV/100 k ohms
Input 0.3 m V/Output 410 mV
2SA564(R) ... . 1
2SA699(Q)(R)... 1
2SB22(BLU) ...1
28C644(S)(T) .. . 2
re
2SC838(R)(S) .. . 12
2SC828(R) ... 2
2SC1226(Q)(R) .. . 1
2SC1327(S)(T) ... 4
NES45B...2
1S188AM... 14 TD-960016-1... 1
WZ177...1 TLR-102...2
1N4002... 9 TLG-102...1
CSA, UL and LA Models: 120V, 60 Hz only
CEE Models: 220V, 50 Hz only
Other Models: 110/120/220/240V, 50/60 Hz (Switchable)
DIMENSIONS 440(W) x 165(H) x 300(D) mm, (17.3” x 6.4” x 11.8’)
WEIGHT 6.8 kg (15.0 Ibs)
NOTES: 1. For improvement purposes, specifications and design are subject to change without notice.
2. Noise reduction circuit made under license from Dolby Laboratories Inc.
The word ‘DOLBY’ and the Double-D symbol are trademarks of Dolby Laboratories Inc.